|
|
Voltage protection |
Tel : +44 1753 688300 Fax : +44 1753 685306 sales@sollatek.com |
![]() |
|
| All electrical and electronic equipment, connected to the mains supply is at risk of being damaged from spikes, surges, lightning, brown-outs, power-cuts (blackouts), power back surges, and over-voltage. The following is a summary of the main types of power problems, causes and how these affect electrical and electronic equipment. |
![]() |
Spikes/Surge: Very short, (one
millisecond) event of very high surge in voltage to thousands of volts and
amps. Spikes are common in all parts of the world and repeated exposure to
spikes will damage electronic equipment and corrupt data. What causes it? Switching on/off of nearby equipment, lightning, motors starting etc. |
![]() |
RFI
(Radio Frequency Interference)/Noise:
High frequency disturbances that occur
within a short period of time (milliseconds). RFI & noise are very common
in all parts of the world and are the main cause of data corruption. What causes it? Generated by high frequency noise from nearby equipment like TV, radio equipment, transmitters, mobile phones, switching on/off of certain loads, fluorescent lights, motor speed controls, light dimmers. |
![]() |
Over-Voltage: Long duration
(milliseconds, seconds, minutes, hours or days) rise in the voltage above
acceptable limits. Depending on the level of the over-voltage, the damage
can be instantaneous, severe and irreparable. What causes it? On return of mains supply after power cuts, under-sized utility oscillating between periods of brown-outs and over-voltage or accidental (e.g. accidental connection between two phases). |
![]() |
Brown-Out: Long duration of low
voltage (milliseconds to seconds, minutes, hours or days). Very common in
parts of the world especially where the power utilities are
over-stretched. Prolonged and frequent brownouts cause the equipment to
malfunction or not work at all. Repeated episodes are certain to cause
damage. Motors and compressors (and therefore fridges, freezers, coolers,
air-conditioners and pumps) are especially at risk. In time, damage is
certain. What causes it? Most commonly an over-stretched utility, especially in areas of poor power distribution infra-structure and remote areas. Common in dry seasons where water is used for electricity generation. |
![]() |
Lightning: Direct or nearby
strikes can cause minor problems or severe disturbances and damage.
Lightning produces spikes/surges, over-voltage or power cuts. What causes it? The surge is generated by either a direct hit, or indirectly striking underground or overhead lines and transmitting high surges to connected equipment in nearby buildings. |
![]() |
Power-cuts: Common in every
country in the world, especially in areas of frequent voltage problems.
Sudden loss of power can cause damage ranging from corruption of data to
mechanical faults as equipment is stopped while in operation. What causes it? Power or sub station failure, breakdown in the distribution network, or simply a plug being pulled out accidentally. |
![]() |
Power-Back Surges: These
typically occur when power returns after a power-cut and connected
equipment receives a surge of electricity at an over-voltage level, which
can be very damaging (see above). What causes it? Power back surges are created by the utility, when it restores supply at an above normal voltage in order to compensate for the demand as connected equipment re-starts simultaneously. |
![]() |
Telecom
surges, spikes and lightning:
Short term, high voltage and current phenomena occurring on the telephone
lines. Can cause irreparable damage to any piece of equipment connected to
the incoming line. The telephone line itself may even be damaged or
destroyed in severe cases. What causes it? Telecom spikes are caused by lightning striking either the telephone line directly or an object near it. |